2018年5月29日 星期二

how to upgrade MMDVM FW to new Version (Support NXDN)

https://drive.google.com/file/d/107O-Wf4-OAa1T1bfADaLST-Vsi6iVHuk/view?ths=true


How To Connect MMDVM BOARD to your GM300 GM338 GM950i
A:Using Software,Pi-star,stm32flash,MMDVMCal(come with pi-star)
B:Using Hardware,raspberry zero w or raspberry 2 B+,GM950i
Ps :Testing GM950i is very Stable then old GM300/GM338
1. hardware Connect









Current PTT+GND+RX+TX is Work

2. Using MMDVM Cal To Test if work!
Current MMDVM board have two version ,old fw don’t support NXDN,new fw support NXDN
If you want update




#stm32flash -w RPT_134.hex /dev/ttyS0



My router is ttyS0,raspberry zero w is ttyAMA0
Caution ,you Must Stop MMDVMHost frist when you Update FW.
When Done ,your fw is new now.

Next Testing Using MMDVMCal  you can see the MMDVM baord is 20180327 new version


If you test USING DMR MD380 pls write TG9 and save .

Then press m to testing DMR MS 1031 Test Pattern,and press Space,Start Transmit ,then ADJUST TX ,if you can hear 1khz sound in MD380( TG9,1)   your adjust is ok, stop ADJUST.
If not Press I ,Change  testing Transmit Inversion,and Try Again.


If DMR testing TX is ok,no need testing P25 Testing Pattern,if you like is better.

MMDVM BOARD Woking Condition:
Power :5V
When testing D-DMR Deviation Mode,you can see TP42 or TX pin is 1.2Khz
Wave in Scope,if TX testing is not good ,pls Try TX Inversion.
Final in pi-star ,is the same Tx Inversion =0 or 1



7 則留言:

  1. Doesn't work for me. Nothing uploads it just hangs. Using STM32Flash version 0.5 on Pi3

    回覆刪除
  2. Did anyone manage to update the fw (firmware)?

    回覆刪除
  3. Finally managed it. Used a CP2102 adapter and connected to a laptop running ubuntu. Upgraded without problems with the jumper installed.

    回覆刪除
  4. Hello, someone does not have an old version of firmware 2017

    回覆刪除