2017年11月17日 星期五

JumboSPOT mmdvm hotspot for pi-star



  • High performance 32-bit ARM processor
  • · Fully assembled and tested
  • · Supports DMR, P-25, D-Star and System Fusion
  • · Onboard LEDs to show status (Tx, Rx, PTT, Mode)
  • · Up to 10mW RF power
  • · SMA antenna connector, UHF antenna included 
  • · Mounts cleanly on all current Raspberry Pi’s including the Pi Zero 
  • · The firmware is pre-loaded and is easily upgraded via software. 
  • · Open source 3D printable case available
  • ·  144-146MHZ,220 Version and 430-450MHz , 433MHZ and 900MHz Version


3 則留言:

  1. I have 2 of your JumboSPOT's but neither of them hears anything. I have followed your instructions but Pi-Star says nothing is heard in any mode.

    Any ideas about what I'm doing wrong?

    回覆刪除
    回覆
    1. hello,pls connect the seller they will help you!

      刪除
    2. Mark Phillips, Note that you need to have your transceiver in "Promiscuous" mode, or have all TGs you want to hear in your Group List.

      刪除