HOW TO INSTALL JumboSPOT(2017/11/17)

HOW TO INSTALL JumboSPOT(2017/11/17)

JumboSPOT is a raspberry module for digital radio IP gateway / hotspot

Key features:

Supports DMR (Brandmeister, DMRplus), D-Star (DCS, REF/DPlus, XRF/DExtra, XLX), System Fusion (FCS, YSFReflector) networks.

about the ANT,if you use inside ant,pls unsolder c27 and sma

if you use the sma and ant unsolder c28 disconnect inside ant

DUAL MODE support VHF,UHF(144,220,434,900)

 download the pi star

http://www.pistar.uk/downloads/

download image file is : Pi-Star_RPi_V3.4.8_08-Dec-2017.zip

press Write wait finished,and powered the rpi

Setting is :

 and pree ptt ,you can listen 3100 talking group

JumboSPOT mmdvm hotspot for pi-star

• High performance 32-bit ARM processor
• · Fully assembled and tested
• · Supports DMR, P-25, D-Star and System Fusion
• · Onboard LEDs to show status (Tx, Rx, PTT, Mode)
• · Up to 10mW RF power
• · SMA antenna connector, UHF antenna included 
• · Mounts cleanly on all current Raspberry Pi’s including the Pi Zero 
• · The firmware is pre-loaded and is easily upgraded via software. 
• · Open source 3D printable case available
• ​
• ·  144-146MHZ,220 Version and 430-450MHz ， 433MHZ and 900MHz Version